CREATE REVIT BEAMS FROM 2-PT AC LINE FAMILIES USING RHINO INSIDE AND GRASSHOPPER

Have you ever wanted an alternate method to create structural roof beams in Revit? Its easy just use a 2-point adaptive component and Grasshopper (which uses the Rhino.Inside.Revit addin)
Just follow the steps below and good luck.

If you would like to see this as a demo watch this youtube channel

If you are not familiar with Rhino Inside read about it here.

If you want the Dynamo equivalent as shown above then read about it here.

If you want more of these types of examples they could be found in my new book

to be published soon.

Thank you readers and good luck with Grasshopper!